ASTM D 4434 PDF
The D Standard Specification established a nationally-recognized definition for. PVC roofing membranes. Section of ASTM D Both the Mil and Mil Duro-Last EV membranes are KEE-containing and comply with ASTM D The benefits of KEE in roofing membranes only go. Buy ASTM D SPECIFICATION FOR POLY(VINYL CHLORIDE) SHEET ROOFING from SAI Global.
|Published (Last):||20 March 2011|
|PDF File Size:||16.56 Mb|
|ePub File Size:||20.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Historical Version s – view previous aztm of standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
This specification covers flexible fiber- or fabric-reinforced sheet made from aatm vinyl chloride resin as the primary polymer intended for use in single-ply roofing membranes exposed to the weather. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The sheet shall contain.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitation prior to use. Work Item s – proposed revisions of this standard.
Link to Active This link will always route to the current Active version of the standard. This abstract is a brief summary of the referenced standard.
Standard – Standard Specification for Poly(Vinyl Chloride) Sheet Roofing ASTM D –
In-place roof system design criteria such as 434 resistance, material compatibility, wind uplift resistance, in-situ shrinkage, among others, are beyond the scope of this specification.
This standard does not purport to address all of the safety concerns, if any, associated with its use.
The physical requirements for which the sheet materials shall be tested on and shall conform accordingly to are as follows: In-place roof system design criteria, such as fire resistance, material compatibility, wind uplift resistance, in-situ shrinkage, among others, are factors that must be considered but are beyond the scope of this specification.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
The sheet shall contain reinforcing fibers or reinforcing fabrics. Combining values from the two systems may result in non-conformance with the standard.